BAT TECH Oscilloscope Break-Out Leads Cable Automotive Test Instruments 4 mm Connectors [HT301]
For use with diagnostic test equipment – instruments
This breakout lead is designed to support the measurement of voltage readings from many [but not all] engine and electronic systems sensors
Connect the breakout lead plugs into the existing wire loom, and insert the two 4 mm banana plugs into the oscilloscope using test lead HT30A, to measure the voltage signals
SUPPORTS:
[depends on sensor plug type and make of vehicle]
multi-point injection nozzle
single-point injection nozzle
induction crankshaft sensor
camshaft sensor
temperature sensor
knock sensor
GM ignition coil
… + more
mechanical injection system - warm-up regulator, subsidiary air valve, temperature timer switch, cold start nozzles
Lead Length:
Red: approx. 300 > 370 mm
Yellow: 900 > 1000 mm
KIT INCLUDES:
1 * break-out lead cable set red / yellow + connector plugs
Details as per the representative images; please check the images to confirm compatibility [does not fit all sensor plugs]